Editing Mitsumi KPQ-E99ZC (section)

==Disassembly==
To disassemble a KPQ-E99ZC keyboard, first remove the four screws from below the front of the keyboard. Next, release the three retaining clips. These can be done without tools: simply raise the two feet, press each of the side retaining clips with your thumb, and use the feet to pull the base up. The centre clip can then be released with just your thumb.

Following a near-full disassembly (where the cable has not been unclipped from the internal back panel), full reassembly is somewhat tricky. The controller board is secured by the back panel, but the back panel if moved will pull the board back out as the cable is soldered directly to the board and then tied to the internal back panel.