Editing Vortex Pok3r (section)

==Programming==
Programming is done using key combinations and is stored permanently in the keyboards micro controller. There is no programming software required or available for the Pok3r. It is impossible to backup/restore the configuration of a Pok3r.
Step 1. Choose the layer (Fn+ <, > or ? key) which you want to program<br />
Step 2. Press Fn + Right CTRL to enter the programming mode (Spacebar right LED steadily lit)<br />
Step 3. Press the key you want to program (Spacebar right LED flashing)<br />
Step 4. Key in the programming content and then press Pn (Spacebar right LED steadily lit again)<br />
Step 5. Repeat step 2 and step 3 to program other keys<br />
Step 6. Press Fn + Right CTRL to exit programming mode ( Spacebar right LED off)<br />

Taken from the '''Pok3r''' manual<ref name="Pok3rManual" />. Please check the manual for further details regarding the default layer, programming and other features.

===Known restraints===
Unlike previous versions of Vortex-made 60% keyboards, the PN key does not act as a temporary layer switch key for the programmable layer. This is due to the increase of programmable layers from one to three and the extended usage of the PN key for backlight configuration.

Early versions (Firmware < 1.1.4) did not include media control keys in the firmware<ref name="multimediaControls">[https://www.reddit.com/r/MechanicalKeyboards/comments/37j3sx/guide_modification_pok3r_media_volume_controls_hw/ Reddit]</ref>. Please upgrade the firmware to solve this.