Editing Phantom instruction guide (section)

=Time=
Below is an estimate on how much time it would take for each step.  Total time will be around 4 to 5 hours if you are doing it the first time and everything works as expected.  Of course it would take less time if you are good at this, longer if you don't do soldering work all the time or if you run into problems.
*Filing the stabilizers' corners on the plate and testing stabilizers fitting: 30 minutes to 60 minutes 
*Inserting diodes: 30 minutes
*Soldering diodes: 30 minutes
*Testing diodes connectivity with multimeter: 15 minutes
*Preparing Teensy legs: 10 minutes to 20 minutes
*Soldering Teensy onto PCB: 10 minutes
*Upload Teensy firmware from computer: 15 minutes
*Test Teensy functionality by shorting switch contacts on PCB: 10 minutes
*Soldering LEDs and resistors: 10 minutes
*Inserting Cherry switches onto mounting plate: 10 minutes (note a few switches' orientation are different than others)
*Aligning and coupling switches on plate with PCB: 10 minutes (note some switches' legs could be bend and must be straightened first)
*Soldering all switches: 30 to 45 minutes
* The rest of the work: install completed Phantom into keyboard case, install keycaps: 30 minutes