Editing Chameleon keyboard controller (section)

==Chip pinout to board connection table==
{| class="wikitable"
|-
! Board connector !! connection type !! IC Pinout !! Notes !! Description
|-
| VS || through 0 inductor || VSS || || Ground connection
|-
| D+ || through 24.4Ohm R || D+ ||  || USB D+ line  
|-
| D- || through 24.4Ohm R || D- ||  || USB D+-line
|-
| VB || Direct || VDD ||  || Power supply
|-
| PD || Direct || XPS2DAT || also connected to ground via pur || External PS/2 port data line with internal pull-up resistor 
|-
| PC || Direct || XPS2CLK|| also connected to ground via pur || External PS/2 port clock line with internal pull-up resistor 
|-
| G7 || Direct || GP07 ||  || GPO pin
|-
| G6 || Direct || GP06 ||  || GPO pin
|-
| G5 || Direct || GP05 || marking unreadable on board || GPO pin
|-
| G4 || Direct || GP04 || marking unreadable on board || GPO pin
|-
| G2 || Direct || GP02 || marking unreadable on board || GPO pin
|-
| G0 || Direct || GP00 || marking unreadable on board || GPO pin
|-
| BIN || Direct || GPO3/BIN || marking unreadable on board || GPO3 or AB rotary B input 
|-
| AIN || Direct || CPO1/AIN || marking unreadable on board || GPO1 or AB rotary A input
|-
| PWM|| Direct || BKPWM ||  || Backlight brightness control: PWM output
|-
| PGC || Direct || PRGCLK ||  || Programming interface clock line 
|-
| PGD || Direct || PRGDAT ||  || Programming interface data line 
|-
| GND || Direct || VDD ||  || Power supply
|-
| RE1 || Direct || RESV ||  || This pin is reserved.
|-
| VC || Direct  || VSS ||  || Ground connection 
|-
| LF || 3.3kOhm R || nLED_FN ||  || FN LED: direct drive
|-
| LK || 3.3kOhm R || nLED_KANA ||  || KANA LED: direct drive
|-
| LO || 3.3kOhm R || nLED_COMP ||  || Composer LED: direct drive
|-
| LS || 3.3kOhm R || nLED_SCROLL ||  || Scroll lock LED: direct drive
|-
| LC || 3.3kOhm R || nLED_CAPS ||  || Caps lock LED: direct drive
|-
| LN || 3.3kOhm R || nLED_NUM ||  || Num lock LED: direct drive
|-
| LU || 3.3kOhm R || SUSPEND ||  || Valid in USB mode. High = keyboard is in suspend mode; low = 
normal running mode.  
|-
| R0-7 || Direct || ROW0-ROW7 ||  || Row lines 0 to 7 for scan matrix with internal pull-down resistor
|-
| C18-C19 || Direct || COL18-COL19 ||  || Column lines for scan matrix
|-
| 6-17 || Direct || COL06-COL19 ||  || Column lines for scan matrix
|-
| 0-5 || Direct || COL00-COL05|| Unmarked on board || Column lines for scan matrix
|-}

<gallery>
File:IMG_8482_(Large).JPG|Board top side
File:IMG_8481_(Large).JPG|Board bottom side
</gallery>

[[Category:Controller boards]]