Editing RAFI RS 74 M SPDT latching (section)

==Disassembly==
An approximate process is as follows:

#Push up on the normally closed terminal to ease the contact up enough to allow the loop more vertical movement; it may be possible to remove it at this stage
#Pry out and remove the slide block, a thumbnail may be useful to push it away from the switch shell
#The follower pin will fall out readily; the spring may fall out, or may remain in slider until coaxed out
#Insert the leg from a pair of tweezers leg under the rear of the slider (where it sits in its guide track) and gently lever it out
#The movable contact has a vertical portion above the terminal; this sits underneath the slider guide post, and has to be gently twisted back so that it can be pulled clear and out
#Push up on the normally open terminal until the vertical part of the contact clears the switch shell enough to be gripped and pulled out; if not done already, the normally closed terminal can also be removed
#Using pliers, some cloth to prevent scuffing and a strong grip, apply sufficient pressure and effort to remove the slide block track block; this block is fitted so tightly that it cannot be reinserted