Editing HID Liberation Device - Instructions

[[File:HID_Liberation_Device_--_Line-up.JPG | 400px |thumb | The HID Liberation Device]]

==Notice==
This will be the instruction guide for the HID Liberation Device. 

==Firmware==
Firmware source code: https://github.com/BathroomEpiphanies/AVR-Keyboard

===Compiling===
====Linux/Windows====
You need to select the correct ''BOARD'' and ''LAYOUT'' variables in the ''Makefile''
 BOARD = hib_liber
 LAYOUT = ansi_iso_jis
 MCU = atmega32u4
 F_CPU = 16000000
 B_LOADER = \"jmp\ 0x7000\"
Then run the make command in a terminal. Always run a ''make clean'' first.
 make clean; make

===Flashing the controller===
====Linux/Windows====
 dfu-programmer atmega32u4 erase
 dfu-programmer atmega32u4 flash avr_keyboard.hex
 dfu-programmer atmega32u4 start

==Schematic==
[[File:HID_Liberation_Device_--_Schematic.png | 400px | Schematic for the HID Liberation Device]]

{{-}}

==See also==


[[Category:Guides]]
[[Category:Keyboard modding]]